True Manufacturing Company TAC-14GS-HC-LD, Руководство по установке

Страница: 6 / 24

TEC_TM_086 REV. B | EN 09/26/22 Page 6 of 24
AIR CURTAIN www.truemfg.com
WARNING! – Units may pose a tipping hazard
while uncrating, during installation, or when
moving the unit.
Uncrating
Required Tools
Required tools include (but may not be limited to) the following:
• Adjustable wrench
• Phillips screwdriver
• Level
Procedure
1.
Remove the outer packaging (cardboard and bubble wrap
or Styrofoam corner and clear plastic). See fig. 1. Inspect for
concealed damage.
Again, immediately file a claim with
the freight carrier if there is damage.
2.
With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the cabinet. See fig. 2
NOTE: Move the unit as close as possible to the final location
before removing the wooden skid. Some models may require
removing the front and/or rear grill/cover to access the
shipping bolts.
3.
If leveling legs or castors will not be used , remove the
cabinet from the wood skid and set the skid aside.
NOTE: DO NOT
lift the cabinet by the countertops, doors,
drawers, or grills.
If leveling legs or castors
will be used , rotate the cabinet on
the skid (see fig. 3) and see the installation instructions on
page #7.
NOTE: Remember to leave cabinet upright for 24 hours before
plugging into a power source. Keys for cabinet with door locks are
located in the warranty packet.
Installation
Fig. 1. Remove the outer packaging.
Fig. 2.
Remove all shipping bolts.
Fig. 3. Remove the cabinet from the wood skid and set aside.