Description
TruAudio is proud to introduce a revolutionary new
design, the Wraith series of invisible in-wall speakers
and subwoofers.
Extremely versatile in their ability to
support both multiroom audio and surround
applications, the Wraith Series literally disappears
into any space.
Box Contents
WR24 Speaker
• 2 in-wall speakers
• 2 wood spacers per speaker
• 2 sets of fiber tape
• 2 sets of speaker overload protection and
crossover (WRPRO), 1 per speaker
WR40 Subwoofer
• 1 in-wall subwoofer
• 1 wood spacer
• 1 set of fiber tape
Speaker Placement - WR24 Speaker
Place wood spacer on the wall where you would like
to install the speaker and draw a line around the
OUTSIDE of the template. Carefully cut along the line
and remove the piece of sheetrock. Make sure the
outside edges of the speaker holes line up with the
studs. Half of the studs should be visible for the
screws to attach. (If the wall is not pre-framed it is
recommended to add a piece of 1x4 wood along the
top & bottom of the cutout for the speaker to attach
to.)
Wiring WR24 Speaker
Run your speaker wires from your amplifier to the “IN”
on the WRPRO protection unit. Then run speaker
wires from the WRPRO “OUT” to the speaker. Attach
the black & red wires to the speaker as seen in the
image below.
Insulation
Fit mineral wool or fiberglass insulation (not included)
behind the speaker, be sure there is no compression
between the insulation and the back of the speaker.
MANDATORY:
The WRPRO MUST BE USED.
The WRPRO must be used in line between the
speaker and your amplifier. The speaker will blow
if you send a signal directly to the speaker and
will not be covered under warranty.
User Manual
The protection unit “WRPRO” serves as an
extended overload protection and crossover that
also reacts to fast impulses. These speakers are
ONLY warranteed if this unit is used. When using the
WRPRO you will get the best performance from your
speakers.
14.5”
Amplifer
WRPRO
WR24
1
