Specifications
WRPRO
Speaker level protection unit and crossover used to enhance the sound and protect the WR24 speakers
from mechanical overload.
Dimensions: 1.9” (48mm) x 3.1” (79mm) x 5.9” (150mm)
WR24
WR40
SoundVision Technologies dba TRUAUDIO
PRODUCT WARRANTY
LIMITED FIVE (5) YEAR WARRANTY TruAudio warrants to the original purchaser, when purchased from an authorized TruAudio Dealer/Distributor
and installed by a TruAudio installer, this product will be free from defective workmanship and materials in the initial installation for the period stated
above. Subject to the additional limitations stated below, does not include damage to associated equipment which may result for any reason from use
with this product, and does not include product failure caused by negligence, improper installation, misuse (e.g. overdriving the amplifier or speaker,
excessive heat or cold or humidity, outdoor installation). TruAudio will, during the warranty period, either repair the defect or replace the product with
a new or remanufactured product or a reasonable equivalent, and arrange at its acceptable expense, to reinstall this product and prepare the surface
of the speaker and mount for finishing, and nothing more. Does not include re-finishing of the wall or speaker.
It is the policy of TRUAUDIO to continuously incorporate improvements into our products. All specifications are
subject to change without notice. If you have any questions regarding this or any other TRUAUDIO products,
please visit www.TruAudio.com
Office: 1-888-858-1555, Monday-Friday 7 am - 6 pm MST.
Email: [email protected]
TruAudio
198 N Old Highway 91
Hurricane, UT 84737 USA
Power:
Impedance:
Freq. Range:
Dispersion:
Max SPL:
Dimensions:
Weight:
50W*
4Ω (2 @ 8Ω)
70 Hz - 18kHz
180º x 180º
105 db 1 w/1 m
24.38” (619mm) x
15.75”(400mm) x
2.2” (56mm)
2.1 lbs
Power:
Impedance:
Freq. Range:
Dispersion:
Max SPL:
Dimensions:
Weight:
150W Max
4Ω
35 - 150 Hz
180º x 180º
108 db 1 w/1 m
39.38” (1000mm) x
15.75”(400mm) x
4.0” (101mm)
25.5 lbs
*Power rating as per application of a high-pass filter. No electronic low-frequency boost must be used. Resulting damages from mechanical
overload are excluded from the warranty.
WR24
WRPRO
WRPRO
Attach the black and red wires from the WRPRO to
driver 1 and then attach the black and red wires from
the other WRPRO to the second driver 2.
To Amplifer
To Amplifer
4
