TruAudio T100, Руководство пользователя

Страница: 6 / 8

How to learn the IR codes:
SET UP
1. Plug the IR receiver into the T100
2. T100 power switch must be OFF
3. Dip switch #2 must be set to IR SET
PROGRAMMING
1. Hard power the T100 on
2. Set dip switch #2 to LEARN (light will flash blue)
3. Aim the remote you want to use at the IR receiver (TV, cable, etc.)
4. Push the first button in the sequence (power off), blue light will flash, wait one second and press the
same button again. The light will flash purple to confirm code.
5. Repeat learning for power on, mute, volume down and volume up.
6. After last button is programmed the blue light will stay on or turn red if no audio source is plugged into
the T100.
7. Set dip switch #2 up to IR SET
8. You are now programmed.
*When learning IR commands, the T100 will always learn in the following order.*
Programming sequence:
• Power off
• Power on
• Mute
• Volume down
• Volume up
IR Reset. When learning the IR codes, if a mistake happens, you can set dip switch #2 to IR SET to
reset the learning process and start again.
NOTE: Learn function will stop after 30 seconds of no activity.
5