Tru-Turf RS48-11D, Руководство пользователя

Страница: 11 / 48

TRU-TURF RS48-11D USA Roll ‘n’ Spike & RS48-11DB Golf Greens Roller Manual 8
Assembly Procedure
Step 1: Mounting the seat to the seat base.
• Use the four 5/16” x ³/4” UNC bolts to fasten the seat to
the seat base.
• Remove armrest screws from the seat, position left and
right side armrest, fasten and tighten.
Step 2: Mount the steering joystick to the steering
shaft.
• Select the steering joystick.
• Slide the joystick into the slot on the top of the
steering shaft, already installed in the steering column
directly in front of the foot pedal controls, insert the
³/8” bolt into the bottom bolt hole, select a comfortable
operating position, joystick forward for extra
operating room or back for less, once determined
insert the other ³/8” bolt into the upper hole and
tighten both bolts securely.
Step 3: Attaching the left-hand trailer arm to machine
body.
• Locate the trailer arm support axle 30mm in diameter
(11/4”) which extends out on the left side of the
machine, remove the circlip from the support axle. Oil
machined portion. Slide the left hand side trailer arm,
onto the axle, replace the circlip, ensuring the circlip is
located in the groove correctly.
Step 4: Attaching dampener strut and right hand
trailer arm.
• Locate the trailer arm support axle 30mm in diameter
(11/4”) which extends out on the right side of the
machine, remove the circlip from the axle. Hold the
right side trailer arm in the vertical position and slide it
part way onto the axle. Locate dampener strut, remove
packing from the unattached end.
• Apply thread lock “Loctite” to the M10 bolt attached to
the dampener strut. Screw the M10 bolt into the strut
support on the trailer arm.
• If necessary use a soft headed hammer and tap the
trailer arm onto the axle until the circlip groove is
revealed, fi t the circlip, ensuring it is located in the
groove correctly.
Step 5: Attaching draw bar to trailer arms.
• Locate the draw bar assembly.
• Gather the ends of the right and left trailer arms.
• Place the draw bar assembly between the trailer arms
and align the holes, ensure the bend is upwards.
• Place one 21/2” x 3/8” bolt through each hole, fi t 3/8”
Nyloc nut to each bolt and tighten securely.
• Test to ensure the trailer catch is correctly locking the
trailer arms in the down position and the catch locking
pin fi ts correctly when transporting the roller, for
safety.
Assembly