Tru-Turf R52-11T, Руководство пользователя

Страница: 8 / 44

TRU-TURF R52-11T Golf Greens Roller Manual 6
Assembly Procedure
Step 1: Mounting the seat to the seat base.
• Use the four 5/16” x 3/4” UNC bolts to fasten the seat to
the seat base.
• Remove armrest screws from the seat, position left
and right side armrest, fasten and tighten.
Step 2: Mount the steering joystick to the steering
shaft.
• Select the steering joystick.
• Slide the joystick into the slot on the top of the
steering shaft, already installed in the steering
column directly in front of the foot pedal controls,
insert the 3/8” bolt into the bottom bolt hole, select
a comfortable operating position, joystick forward
for extra operating room or back for less, once
determined insert the other 3/8” bolt into the upper
hole and tighten both bolts securely.
Step 3: Attaching the left-hand trailer arm to machine
body.
• Locate the trailer arm support axle 30mm in diameter
(1¼”) which extends out on the left side of the
machine, remove the circlip from the support axle. Oil
machined portion. Slide the left hand side trailer arm,
onto the axle, replace the circlip, ensuring the circlip is
located in the groove correctly.
Step 4: Attaching dampener strut and right hand
trailer arm.
• Locate the trailer arm support axle 30 mm in diameter
(1¼”) which extends out on the right side of the
machine, remove the circlip from the axle. Hold the
right side trailer arm in the vertical position and slide
it part way onto the axle. Locate dampener strut.,
remove packing from the unattached end.
• Place strut onto locating pin and push completely on,
insert washer and cotter pin in place to prevent strut
from coming off the shaft.
• If necessary use a soft headed hammer and tap the
trailer arm onto the axle until the circlip groove is
revealed, fi t the circlip, ensuring it is located in the
groove correctly.
Step 5: Attaching draw bar to trailer arms.
• Locate the draw bar assembly.
• Gather the ends of the right and left trailer arms.
• Place the draw bar assembly between the trailer arms
and align the holes.
• Place one 2¾” x 3/8” bolt through each hole, fi t 3/8”
Nyloc nut to each bolt and tighten securely.
• Test to ensure the trailer catch is correctly locking the
trailer arms in the down position and the catch locking
pin fi ts correctly when transporting the roller, for
safety.
Step 6: Attaching wheels to trailer arms.
• Locate the two wheels for the left and right side trailer
arms.
• Check tires for the correct air pressure, approximately
18psi. Do not exceed this pressure. The tires act as the
suspension, hence the low P.S.I.
Assembly