Tru-Turf R50-11, Руководство пользователя

Страница: 63 / 70

61 www.turturf.com R50-11 Owners Manual
INSTRUCTION RS2010 R50 BRUSH OPTION KIT ASSEMBLY
INSTALLATION OF SHIMS
SHIMS (T3116) [SUPPLIED 6 OFF] CAN BE INSERTED HERE ON BOTH
SIDES TO COMPENSATE THE WEARING OF THE BRUSHES, AS REQUIRED
INSTALLATION OF REPLACMENT BRUSH
RIVET IS ONLY USED WITH RS2013-15 (FLEXI STRIP), BUT IS NOT USED WITH BRUSH INFILL RS2013-40
NOTE: SIDES OF AL. EXTN CRIMPED ON ONE(1) END & BOTH SIDES TO CAPTURE INFIL INSTEAD OF THE RIVET
RIVET
CHOICE OF BRUSH INFIL
RS2013-15 STANDARD 0.015 in
RS2013-40 AGGRESSIVE 0.040 in
ALUMINIUM EXTRUSION
CRIMP BOTH SIDES OF TRACK
TO CAPTURE INFIL IN PLACE
WHEN NOT USING RIVET
CRIMP
SHIM
SLIDE BRUSH INFIL ALONG THE
ALUMINIUM EXTRUSION TRACK IN OR OUT
SLIDE SHIM BETWEEN THE CARRIAGE AND THE BRUSH
ALUMINIUM EXTRUSION - USE PAIRS OF SHIMS AT A
TIME TO SPACE THE BRUSH AWAY THE OPTION H FRAME
AS REQUIRED - EACH SHIM HEIGHT IS 3mm AND IN
MULTIPLES CAN BE UTILISED FOR THE DESIRED EFFECT BY
ADJUSTING THE HEIGHT AWAY THE OPTION H FRAME
UNTIGHTEN THE BOLTS EQUALLY BY APPROX. 5-10mm BEFORE SLIDING THE PAIRS OF SHIMS
(TRY AVOID THE REMOVING OF THE BOLTS FROM THE CARRIAGE PLATES, SO NOT TO START THREAD AGAIN)
OPTION H FRAME CARRIAGE
BRUSH & EXTRUSION ASSEMBLY
Options - Brush Insert Installation
INSTRUCTION RS2010 R50 BRUSH OPTION KIT ASSEMBLY
INSTALLATION OF SHIMS
SHIMS (T3116) [SUPPLIED 6 OFF] CAN BE INSERTED HERE ON BOTH
SIDES TO COMPENSATE THE WEARING OF THE BRUSHES, AS REQUIRED
INSTALLATION OF REPLACMENT BRUSH
RIVET IS ONLY USED WITH RS2013-15 (FLEXI STRIP), BUT IS NOT USED WITH BRUSH INFILL RS2013-40
NOTE: SIDES OF AL. EXTN CRIMPED ON ONE(1) END & BOTH SIDES TO CAPTURE INFIL INSTEAD OF THE RIVET
RIVET
CHOICE OF BRUSH INFIL
RS2013-15 STANDARD 0.015 in
RS2013-40 AGGRESSIVE 0.040 in
ALUMINIUM EXTRUSION
CRIMP BOTH SIDES OF TRACK
TO CAPTURE INFIL IN PLACE
WHEN NOT USING RIVET
CRIMP
SHIM
SLIDE BRUSH INFIL ALONG THE
ALUMINIUM EXTRUSION TRACK IN OR OUT
SLIDE SHIM BETWEEN THE CARRIAGE AND THE BRUSH
ALUMINIUM EXTRUSION - USE PAIRS OF SHIMS AT A
TIME TO SPACE THE BRUSH AWAY THE OPTION H FRAME
AS REQUIRED - EACH SHIM HEIGHT IS 3mm AND IN
MULTIPLES CAN BE UTILISED FOR THE DESIRED EFFECT BY
ADJUSTING THE HEIGHT AWAY THE OPTION H FRAME
UNTIGHTEN THE BOLTS EQUALLY BY APPROX. 5-10mm BEFORE SLIDING THE PAIRS OF SHIMS
(TRY AVOID THE REMOVING OF THE BOLTS FROM THE CARRIAGE PLATES, SO NOT TO START THREAD AGAIN)
OPTION H FRAME CARRIAGE
BRUSH & EXTRUSION ASSEMBLY