Play/Pause:
This controls the play or pause of the Bluetooth enabled device that is connected to the soundbar.
Skip forward/back:
The skip forward or skip back buttons will change the track on the Bluetooth enabled device
currently paired to the soundbar.
Release:
Releases or disconnects any Bluetooth device that is currently connected to the soundbar. This frees the
device for a new connection. See the Bluetooth Release button on the Front Panel section.
TV REMOTE SUPPORT
www.TruAudio.com
888.858.1555
198 North Old Highway 91 Hurricane, UT 84737
The soundbar will support /- IR codes from Samsung, Panasonic, Sony, LG, Sharp, Visio, and JVC. This
means that out of the box you can use one of these TV manufacturers’ remotes to control the volume on the sound
-
bar. This allows users to only use a single remote for operation.
For ideal operation, disable the TV speakers by navigating to the audio settings in the TV menu and enable external
speakers or whichever setting is appropriate. Consult the manual of the TV manufacturer.
The soundbar has an ultra-low power sleep mode. When in this mode the Power LED on the soundbar will show a
very dim red. For normal operation, we recommend leaving the soundbar on at all times. This allows the user to use
only a single remote.
For convenient use in an automation system, use the IR port on the rear panel of the soundbar to connect to the IR
out of an automation controller. Refer to “SLIM-PWR44 IR Hex Codes” document for the full list of IR codes, includ
-
ing discrete on/off and discrete source selection.
www.truaudio.com/slim-pwr44.html
Dim Mode:
This mode turns off the Volume LED for a dim operation. In this mode, only the power LED will remain
on. Enable this mode by holding the Source button for 15 sec until the Volume LED flashes red. Repeat the same
button press to disable this setting.
TV Codes Off:
This setting turns off the ability for the soundbar to read the volume codes from all TV remotes. This
is useful in the case your TV internal speakers cannot be set to off in the TV menu or the soundbar cannot be set to
mute without an on-screen indication. Enable this setting by holding the Bluetooth Release for 15 sec until the
Volume LED flashes red. Repeat the same button press to disable this setting.
Reset to Default:
To reset all settings simply disconnect the soundbar from its power source for 20 sec then
reconnect. This will turn off the Dim Mode, TV Codes Off setting, and any enabled EQ modes.
USE IN AUTOMATION SYSTEM
SPECIAL SETTINGS
Manual
SLIM-
PWR44
