12
Operation (continued)
HOLDING THE TRIMMER
Always wear eye, hearing, foot and body protec-
tion to reduce the risk of injury when operating
this unit.
Before operating the unit, stand in the operating posi-
tion (Fig. 5-4). Check for the following:
•
The operator is wearing eye protection and proper
clothing.
•
The right arm is slightly bent, and the hand is hold-
ing the shaft grip.
•
The left arm is straight, and the hand is holding the
D-handle.
•
The unit is at waist level.
•
The cutting attachment is parallel to the ground and
easily contacts the vegetation to be cut without the
operator having to bend over.
ADJUSTING TRIMMING LINE LENGTH
The AFS™ cutting attachment (Automatic Feed
System) automatically feeds out cutting line as needed.
A blade on the cutting attachment shield will cut the
line to the proper length if excess line is released.
NOTE: If the lines stops feeding, this is usually a
sign that the cutting attachment requires new line.
See Section 6, Maintenace, Line Installation.
NOTE: Do not rest the AFS cutting attachment on
the ground while the unit is running .
Do not remove or alter the line cutting blade
assembly. Excessive line length will make the
clutch overheat. This may lead to serious person-
al injury or damage to the unit.
Some line breakage will occur from:
•
Entanglement with foreign matter
•
Normal line fatigue
•
Attempting to cut thick, stalky weeds
•
Forcing the line into objects such as walls or fence
posts
TIPS FOR BEST TRIMMING RESULTS
•
Keep the cutting attachment parallel to the ground.
•
Do not force the cutting attachment. Allow the tip
of the line to do the cutting, especially along walls.
Cutting with more than the tip will reduce cutting
efficiency and may overload the engine.
•
Cut grass over 8 inches (200 mm) by working from
top to bottom in small increments to avoid prema-
ture line wear or engine drag.
•
Cut from left to right whenever possible. Cutting to
the right improves the unit's cutting efficiency.
Clippings are thrown away from the operator.
•
Slowly move the trimmer into and out of the cutting
area at the desired height. Move either in a for-
ward-backward or side-to-side motion. Cutting
shorter lengths produces the best results.
•
Trim only when grass and weeds are dry.
•
The life of your cutting line is dependent upon;
•
Following the previous trimming techniques
•
What vegetation is being cut
•
Where it’s being cut
For example, the line will wear faster when trimming
against a foundation wall as opposed to trimming
around a tree.
Fig. 5-4
Содержание TB2000
Страница 21: ...21 Notes...
