Set Screw (3x4mm)
Set Screw (2mm)
Rod (2x400mm)
Set Screw (2mm)
Washer (2mm)
Linkage Stopper
1
1
1
1
1
4
4
Washer (4x8mm)
4
Rod (1.7x700mm)
Blind Nut (4mm)
Screw (4x25mm)
Set Screw (3x4mm)
1
Matal douel (3x600mm)
163 mm
5.2mm
Blind Nut
4
Blind Nut (4mm)
In case of 2-cycle & 4-cycle engine.
4
Blind Nut (4mm)
Engine mount (68x105mm)
Linkage Stopper
4
4
12
4
Washer(4x8mm)
Screw (4x35mm)
Spring Washer (4mm)
Nut (4mm)
2
4
Screw (4x25mm)
2
Fuel tank (550cc)
1
4
Clevis
4
4
Copper joiner
Aluminum tube(3x6mm)
Washer (4x8mm)
Screw (4x25mm)
Washer (4x8mm)
Screw (4x35mm)
Washer (4x8mm)
Nut (4mm)
Spring Washer (4mm)
4mm
1
Matal tube (3x600mm)
1
Rod (1.7x700mm)
Assemble the throttle linkage.
The side view when the engine install completion.
Drill four holes at the diameters as shown for engine
mount.
Assemble the engine.
The front view of the engine install completion.
10
54
53
52
50
51
Accessory list for the coming installation steps.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
2x7mm
3mm
Elevator
1mm
Tailing
edge
Make sure they are in
the right position while
installing.
1
1
Screw (2x10mm)
Nut (2mm )
1
Copper ball (2mm )
2x7mm
U-style wire
2mm
Metal arms
Screw (2x10mm)
Nut (2mm )
Copper ball
4mm
4
Wooden dowel (4x30mm)
1
Rib template (3mm ply)
4mm
Trim the shaded section
Drill holes to appropriate position in the stabilizer and
epoxy it to the fuselahe as below.
Glue the elevator to the stabilizer by CA and epoxy.
Drill two holes at the stabilizer root base on rib template
and epexy the metal dowel in them.
Set the U-style wire through the tail of fuselage as
below.
Keep some space about 1mm width between the
elevator and horizontal tail edge.
A ccording to thr rib template drill holes to the tail of
fuselage as below.
7
37
36
33
35
34
38
