Troy-Bilt 24B-060F766, Руководство оператора

Страница: 11 / 20

11
4
Operating
Your Yard
Vacuum
NOTE:
In general, raise
the nozzle height to vacuum
a thick layer of leaves.
Lower the nozzle height for
smoother surfaces.
�
�
Figure 12
IMPORTANT
: The flail screen is located inside the
housing in the discharge area. If the flail screen
becomes clogged, remove and clean as instructed in
MAINTAINING YOUR YARD VACUUM on page 12. For
best performance, it is also important to keep the chipper
blade sharp.
WARNING: Do not at any time make
any adjustments without first stopping
engine and disconnecting spark plug
wire.
Using The Hose Assembly
1. Place nozzle/hose vac lever in the bottom position on
the nozzle to redirect vacuum to the hose assembly.
See Figure 12.
2. The spring loaded pin must be in the second hole of
the hose adapter to operate the hose assembly. See
Figure 12.
3. Unhook the hose from upper and lower hose handle
brackets and grasp the hose handle to guide the hose
while vacuuming yard waste such as leaves or pine
needles in hard to reach places.
Nozzle Height Adjustment
The nozzle can be adjusted to any six positions, ranging
from 5/8” to 4 1/8” ground clearance. The nozzle height
has to be adjusted according to yard conditions.
1. Depress nozzle height adjustment lever towards
wheel. See Figure 13.
2. Move the height adjustment lever forward or backward
to adjust the nozzle upwards or downwards. Make
sure both levers are in the same position.
3. Release lever towards deck.
NOTE
: In general, raise the nozzle height to vacuum
a thick layer of leaves. Lower the nozzle height for
smoother surfaces.
�
�
�
Figure 13