11
USING THE ELECTRIC START ACCESSORY
STOPPING INSTRUCTIONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the OFF (O) position until
the engine comes to a complete stop (Fig. 9).
This unit can be started with an optional electric start accessory
(items sold separately). Refer to the electric start accessory
operator’s manual for the proper use of this feature.
Please contact your local retailer, call the Customer Support
Department or visit our website for more information.
Item No.
Description
49M2027P966 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Electric Starter
49MESCBP966 . . . . . . . . . . . . . . . . . . . . . . . . . . . .Engine Starter Bit
49MRBESY966 . . . . . . . . . . . . . . . . . . . . . .Cordless Electric Starter
Fig. 12
Electric Start
Port
STARTING INSTRUCTIONS
1. Check the oil level. Refer to
Checking the Oil Level
.
2. Fill the fuel tank. Refer to
Fueling the Unit
.
NOTE:
There is no need to turn the unit on. The On/Off switch is in
the ON ( I ) position at all times (Fig. 9).
3. Slowly press and release the primer bulb
10 times
(Fig. 10).
4. Move the choke lever to
Position 1
(Fig. 10).
5. Crouch in the starting position (Fig. 11).
6. Insert the electric start accessory into the electric start port (Fig. 12).
Refer to the
Operation
section of the electric start accessory
operator’s manual.
NOTE: SQUEEZE
and
HOLD
the throttle control for
ALL
further steps.
7. Squeeze and hold the throttle control (Fig. 9). Run the electric
start accessory for 2 seconds.
8. Continue to squeeze the throttle control. Move the choke lever
to
Position 2
(Fig. 10).
9. Continue to squeeze the throttle control. Run the electric start
accessory in intervals no longer than 2 seconds each until the
unit starts.
10. Remove the electric start accessory from the unit.
11. Continue to squeeze the throttle control. Allow the engine to
warm up for 30 to 60 seconds.
12. Continue to squeeze the throttle control. Move the choke lever
to
Position 3
(Fig. 10) and continue warming the engine for an
additional 60 seconds. The unit may be used during this time.
IF...
the engine does not start, begin the starting procedure with step 3.
IF...
the engine fails to start after a few attempts, move the choke
lever to
Position 3
and squeeze the throttle control. Run the
electric start accessory in intervals no longer than 2 seconds
each until the unit starts. The engine should start. If it does not,
repeat this instruction.
IF THE UNIT WAS RUN FOR 10-15 MINUTES AND THE ENGINE
IS HOT...
perform steps 3 - 8 to restart the engine. Continue to
squeeze the throttle control. Run the unit for
2-5
minutes, or as
needed.
The unit may be used during this time.
Then move
the choke lever to
Position 3
.
If the engine speed fluctuates in
Position 3
, squeeze and hold
the throttle control, move the choke lever to
Position 2
, and run
the unit for
2-5
minutes, or as needed.
The unit may be used
during this time.
Then move the choke lever to
Position 3
.
