EN
5
dehumidifier TTR 50 E
Information about the device
Device description
The device
TTR 50 E
works on the desiccant principle without a
compressor and without any cooling agent.
The fully automatic control and the condensation tank with
integrated overflow protection ensure fault-free operation.
The fan sucks in damp room air via the air inlet with air filter,
the condenser and the desiccant wheel located behind it.
Within the internal regeneration circuit the air is led via a
heating element, it dries the desiccant wheel and leads the
moist, warm air through the condenser. At the cooler
condenser, heat is withdrawn from the room air and cooled
below dew point. The water vapour contained in the room air
precipitates in form of condensate. The condensate drops into
the condensation tank. Optionally, the condensate can be
discharged via a condensation hose connected to the
connection opening.
The drier air, thus conditioned, is fed back to the room air via
the air outlet. The drier air mixes with the air in the room. The
relative humidity in the room where the device is positioned is
reduced by the constant circulation of the room air.
A float is attached inside the condensation tank, which in case
of a filled condensation tank interrupts the dehumidification.
When switching off, the device emits an acoustic signal and the
Full
LED on the control panel is illuminated (see Operation
chapter). The indicator light only goes out again once the
emptied condensation tank is reinserted.
The device can reduce the relative humidity of a room to
approx. 50 %.
In addition, the device may also be used as a kind of clothes
dryer to dry wet laundry.
Device depiction
1
2
3
4
5
6
7
8
No.
Designation
1
Handle
2
Control panel
3
Air outlet
4
Condensation hose connection
5
Condensation tank
6
Air inlet
7
Humidity sensor
8
Air filter
