10
EN
dehumidifier TTK 70 HEPA
Setting the timer
Note
The device must not be left unattended in a freely
accessible room with an activated timer.
The timer allows to switch the device off automatically after a
preset number of hours.
The function can be set in addition in all operating modes. The
number of hours can be set in hourly increments (1 h to
max. 24 h).
Please proceed as follows to set the timer:
ü
The device is switched on.
1. Press the
Timer
button (
14
).
2. Repeatedly press the
Up
button (
16
) or the
Down
button (
17
) to set the desired number of
hours (0 to 24).
ð
The set value flashes on the segment display for
approx. 5 seconds, then the relative humidity level is
displayed again.
ð
The LED (
24
) is illuminated.
ð
The device switches off after the predefined time.
Info
If you are not sure to which number of hours the timer
has been set to, you can display the set value by briefly
pressing the
Timer
button.
Notes regarding automatic switch-off:
• Manually switching the device off disables the automatic
switch-off function.
• If you select 0 hours, the timer will be off.
Memory function
If you switch the device back on again, the settings selected for
the operating mode, the relative humidity level and fan speed
are saved. If a timer has been set, it will not be saved.
The device memorises the settings even during short power
failures. In this case, the device automatically switches back on.
The previous settings are saved except for the timer.
Auto stop function
Once the condensation tank is full, the device will stop
automatically. The LED (
20
) is illuminated. Empty the
condensation tank as described in section
Emptying the
condensation tank
.
Locking function
The locking function locks using the buttons on the control
panel.
1. Press the
Timer
button (
14
) for approx. 2 seconds to
activate the child lock.
ð
The segment display indicates
LC
:
ð
Making inputs on the control panel is locked.
2. Press the
Timer
button (
14
) for approx. 2 seconds if you
want to deactivate the child lock function.
ð
The segment display indicates the relative humidity
level again.
ð
The buttons on the control panel are unlocked.
Indication of the room temperature
1. Press the
Up
button (
16
) for approx. 3 seconds.
ð
An acoustic signal is emitted and the room air
temperature flashes on the segment display.
ð
The
°C
LED (
23
) is illuminated.
ð
After approx. 5 seconds, the segment display indicates
the relative humidity level again.
Operation with hose attached to the condensation
connection
For continuous operation or unattended dehumidification, please
connect the supplied condensation drain hose to the device.
ü
The supplied hose (diameter = 10 mm) is ready for use.
ü
The device is switched off.
1. Remove the condensation tank.
