Trotec TEH 100, Руководство по эксплуатации

Страница: 15 / 84

Operating manual – TEH 70 / 100 B-4 EN
Switching off the electric heater
Switch the electric heater off by setting the turn control to position 0.
Caution!
Damage to the device due to overheating.
Do not switch off the device by pulling out the power
cord. This may cause the device to overheat.
Switch off the device properly. Do not disconnect the
power plug before the fan motor has come to a complete
standstill.
11. Installation and commissioning
Danger!
Risk of injury due to improper operation.
The device may only be used by persons who have been
trained how to operate the device.
For installation and commissioning, proceed as follows:
Check that the scope of delivery of your electric heater is com-
plete. If an accessory part is missing, please contact the Trotec
customer service or the specialist dealer from whom you pur-
chased the device.
Check the device and its connection parts for possible damage.
Inspect the device prior to each commissioning and check that it
is in proper condition during operation.
Warning!
Risk of injury due to damaged devices.
Do not use any damaged devices or components!
In the case of damage to the electric heater, have
it repaired by a certified special workshop before
use.
Observe the requirements described in chapter "Installation con-
ditions".
Ensure that the properties of the applied power connection com-
ply with the requirements stated on the name plate or in the
chapter "technical data".
Ensure that the fan can move freely each time before turning on
the device. Small objects in the rotation range of the fan can be
removed with compressed air. In the event of major malfunctions,
always contact a certified specialist workshop. Please observe
the information stated in the chapter "Maintenance and clean-
ing". The device must only be disassembled or repaired by au-
thorised technicians!
Connect the power supply cable to a properly secured mains
socket (400 V / 50 Hz / 32 A). On construction sites, a residual
current circuit breaker (RCD) must be connected upstream of the
mains socket according to VDE 0100/0105.
Position the device at the desired location.
Lock the castors on the device to ensure that it is stands securely
The electric heater is now ready for operation. Use the device according
to the functions described in chapter "Functions and operation".
12. Transport and storage
Transport
Switch the device off as described in chapter "Functions and
operation".
Wait until the device has cooled down.
Transport the electric heater by carrying it with the provided han-
dle (4).
On the bottom, the electric heater is equipped with lockable cast-
ers to provide mobility of the device for transport over short dis-
tances. Lock the castors.
During transport by means of a vehicle, protect the device from
vibrations and slipping .
Storage
If the electric heater is not used for a longer period of time, it must be
stored appropriately so that it cannot cause personal injury or property
damage and the device itself cannot become damaged. The following
points are particularly important:
Always disconnect the device from the power supply.
The storage location should be as free from dust as possible to
avoid excessive dirtying of the device. Cover the device.
During storage, the TEH 70 / 100 and particularly its electrical
components must be protected from moisture (e. g. snow, rain).
During storage, the device must be protected from general cli-
matic conditions (e. g. storm).
In the case of an elevated storage place, the device must be se-
cured against falling in order to avoid injuries to persons and
damage to the device.
Lock the castors (1) to ensure that the device stands securely.
13. Maintenance and cleaning
In order to ensure proper operation, the electric heater should be main-
tained and cleaned regularly.
Danger!
Risk of injury
Always disconnect the device from the power supply
before cleaning or carrying out any maintenance.