Trotec TDS 10 M, Оригинальное руководство пользователя

Страница: 6 / 17

6 EN ceramic heater TDS 30 M / TDS 50 M
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before transporting the device, observe the following:
• Switch the device off.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Do not use the power cable to drag the device.
• Allow the device to cool down sufficiently.
Storage
Before storing the device, proceed as follows:
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• in an upright position where it is protected from dust and
direct sunlight
• with a cover to protect it from invasive dust, if necessary
• Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and start-up
Scope of delivery
• 1 x Device
• 1 x Transport handle ( TDS 50 M only)
• 2 x Screw ( TDS 50 M only)
• 2 x Washer ( TDS 50 M only)
• 1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Use tools suitable for the intended task.
Mounting the transport handle
The transport handle of the device TDS 30 M is preassembled.
Prior to initial start-up, the transport handle must be attached to
the device
TDS 50 M .
1. Loosen the two screws and the two washers from the top
of the housing.
2. Use the screws and washers to mount the transport
handle.