EN
7
electric heater TDE 25 / TDE 65 / TDE 95
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a carry
handle.
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Allow the device to cool down sufficiently.
Storage
Before
storing the device, proceed as follows:
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
Store the device in a dry location and protected from frost
and heat.
•
Store the device in an upright position where it is protected
from dust and direct sunlight.
•
If required, use a cover to protect the device from invasive
dust.
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
•
1 x device
•
1 x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
The device may only be used in environments with no
excessive formation of dust.
•
Set the device up in an upright and stable position.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
