EN
9
convector TCH 1500 E
Child lock
The device is equipped with a child lock function that is to
prevent children from changing the settings of the device.
Activate the child lock function as follows:
1. Simultaneously press and hold the
increase value
(10) and
decrease value
(15) buttons for approx. 3 seconds.
ð
The child lock function is activated.
ð
The
child lock active
indication (20) lights up on the
display.
ð
All buttons on the control panel and the remote control
are inhibited except for the
on/off
(13) button.
ð
When the child lock function is activated, the switched-off
device can only be switched on after deactivation of the
child lock function
For deactivating the activated child lock function, proceed as
follows:
1. Simultaneously press and hold the
increase value
(10) and
decrease value
(15) buttons for approx. 3 seconds.
ð
The child lock function is deactivated.
ð
The
child lock active
indication (20) on the display goes
off.
ð
All buttons on the control panel and on the remote
control are working again.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
1. Switch the device off.
2. Hold onto the mains plug while pulling the power cable out
of the mains socket.
3. Allow the device to cool down sufficiently.
4. Clean the device according to the Maintenance chapter.
5. Store the device according to the Storage chapter.
Errors and faults
Warning of electrical voltage
Tasks which require the housing to be opened
must only be carried out by authorised specialist
companies or by Trotec.
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
•
Check the power connection.
•
Check the power cable and mains plug for damages.
•
Check the on-site fusing.
•
Check the room temperature. The room thermostat may
have switched off, because the desired room temperature
has been reached.
•
The room thermostat might be defective. Have a defective
room thermostat replaced by a specialist electrical
company.
•
Check whether the overheating protection has tripped, see
chapter Safety.
•
Wait for 10 minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
The device is switched on, but the heating is not operating:
•
Check the room temperature. The room thermostat may
have switched off, because the desired room temperature
has been reached.
•
Check whether the overheating protection has tripped, see
chapter Safety.
•
The heating resistor might have blown. Have a defective
heating resistor replaced by a specialist electrical
company.
•
The room thermostat might be defective. Have a defective
room thermostat replaced by a specialist electrical
company.
The device does not respond to the infrared remote control:
•
Check whether the distance between remote control and
device is too large and reduce it if necessary.
•
Make sure there are no obstacles, such as furniture or
walls, between the device and the remote control. Ensure
visual contact between device and remote control.
•
Check the charging status of the batteries and change
them if required.
•
If the batteries have only just been changed, check them
for correct polarity.
