8
EN
LED construction site spotlight PWLS 10-50S
Shutdown
•
Switch the device off by setting the on/off switch (
1
) to
position
0
.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Unplug all external power cables from the device by
holding onto the mains plug.
•
Allow the device to cool down.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Designation
Article number
Cable drum
7.333.000.370
High-quality extension cable 15 m 7.333.000.372
High-quality extension cable 20 m 7.333.000.376
High-quality extension cable 25 m 7.333.000.369
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
The device is not lit:
•
Check whether the power cable is connected correctly.
•
Check the power cable and mains plug for damage. If you
notice damages, do not try to take the device back into
operation.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
•
The LEDs are defective. They cannot be replaced. Contact
the Trotec customer service.
The overheating protection has tripped:
1. Remove the plug of the power cable from the mains socket
and allow the device to cool down.
2. Investigate the cause of overheating.
Note
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
The device still does not operate correctly after these
checks:
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
Maintenance
Notes on maintenance
The device does not require maintenance.
Cleaning
The device should be cleaned before and after each use.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
•
Clean the device with a soft, damp and lint-free cloth.
Make sure that no moisture enters the housing. Protect
electrical components from moisture. Do not use any
aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
•
Dry the device with a soft, lint-free cloth.