EN
7
LED construction site spotlight PWLS 10-50S
2. Place the edge protection (
4
) on the surface LED (
1
).
4
1
Connecting additional devices
Warning of electrical voltage
When connecting external devices, make sure that the
mains voltage of the external devices matches the
mains voltage of the device PWLS 10-50 S.
Risk of electric shock if the technical data are not
observed!
Proceed as follows to connect external devices to the two
sockets (
5
) of the device.
1. Install the supply lines of the consumers to be connected.
ð
Do not create tripping hazards when laying the cables.
2. Insert the mains plug into a properly secured socket (16 A
fuse).
3. Open the cover (
6
) of a socket (
5
) at the device.
4. Plug the external power cable into the socket (
5
).
5
6
5. Repeat the first two steps to connect a second power cable
to the second socket (
5
).
Operation
Tips and notes on handling the LED construction site
spotlight
General information:
•
Avoid looking directly into the light source.
•
Use the devices only for a temporary illumination of indoor
and outdoor areas, e.g. for construction sites.
•
The LED construction site spotlights are particularly suited
for illuminating larger areas.
Warning of hot surface
Some parts of this product can become very hot and
cause burns. Particular attention has to be given where
children and vulnerable people are present!
Warning
Do not look directly into the LEDs! The optical radiation
can be harmful for your eyes.
Warning of electrical voltage
Do not touch the device's power cable or power cable
connection with wet or damp hands.
Note
Make sure that the power cable is guided along the
back of the device. Never guide the power cable along
the front of the device!
Note
Do not connect the device at ambient temperatures
below -20 °C or above 45 °C, otherwise it will be
damaged!
Switching the device on
Please proceed as follows to switch the device on:
1. Insert the mains plug into a properly fused mains socket.
2. Set the on/off switch (
3
) to position
I
.
ð
The device switches on in level 1. The surface LED (
1
) is
illuminated.
3. Set the on/off switch (
3
) to position
0
.
ð
The device switches off and the surface LED (
1
) goes
out.
4. Set the on/off switch (
3
) back to position
I
.
ð
The device switches on in level 2. The surface LED (
1
) is
illuminated.
