EN
6
Operating manual – tacker PTNS 10-230V
Scope of delivery
•
1 x Device
PTNS 10-230V
•
400 x Staple, type 53, length: 10 mm, width: 11.4 mm
•
100 x Wire nail, type 47, length: 14 mm, width: 1.8 mm
•
1 x Manual
Technical data
Parameter
Value
Model
PTNS 10-230V
Mains connection
1/N/PE ~ 220 – 240 V / 50 Hz
Power input
45 W
Impact frequency
20 spm
Fastener type: staple
Type
Length
Width
Thickness
53
6 – 14 mm
11.4 mm
0.74 mm
Fastener type: wire nail
Type
Length
Width
47
15 mm
1.8 mm
Max. holding capacity of
magazine
100 staples, 50 wire nails
Protection class
II /
Plug type
CEE 7/17
Cable length
3 m
Weight
0.6 kg
Vibration information
according to EN 60745
Vibration emission value a
h
4.678 m/s²
Uncertainty K
1.5 m/s²
Sound values according to
EN 60745
Sound pressure level L
pA
73.82 dB(A)
Sound power L
WA
84.82 dB(A)
Uncertainty K
3 dB
Wear hearing protection.
Excessive noise can lead to hearing loss.
Information on noise and vibration:
•
The vibration level specified in these instructions was
determined by means of a measuring method standardized
in EN 60745 and can be used for a device comparison. The
specified vibration emission value may also be used for a
preliminary assessment of the exposure.
Caution
Vibration emissions can cause a health hazard if the
device is used for an extended period of time or if it is
not properly handled and maintained.
•
The vibration level will change depending on the
application of the power tool and may in some cases differ
from the value specified in these instructions. The vibration
load may be underestimated if the power tool is used
regularly in such a way. For a precise estimation of the
vibration load during a certain work period, it is also
important to consider the periods during which the device
is switched off, or is running but not actually employed.
This can reduce the vibration load over the entire work
period significantly.
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
Storage
Before
storing the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
•
Clean the device as described in the Maintenance chapter.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
ambient temperature below 40 °C
•
protected from dust and direct sunlight.