12
EN
routing machine PRTS 10-1200
Setting the milling depth
Info
The step buffer has 3 preset steps.
Info
Check the setting of the milling depth before starting
the actual milling process by carrying out a milling test
on a waste piece.
ü
Make sure that the locking lever (
4
) is locked.
1. Place the device on a flat surface with the milling cutter
inserted.
2. Turn the step buffer (
9
) until it engages with the lowest
step below the depth stop (
12
).
9
3. Loosen the wing screw (
11
) on the depth stop (
12
) and, if
required, turn the control dial for the fine adjustment (
13
)
to position
0
, with the
0
on the scale pointing towards you.
4. If required, release the locking lever for the milling depth
lock (
4
) by turning it upwards and slowly push the device
downwards until the milling cutter touches the workpiece.
5. Lock the locking lever for the milling depth lock (
4
) by
turning it downwards.
I.
II.
4
6. Slide the depth stop (
12
) down until it rests on the step
buffer (
9
).
7. Set the slider with the index marker (
35
) to position
0
on
the milling depth scale (
34
).
35
34
8. Then set the depth stop (
12
) to the desired milling depth
and tighten the wing screw (
11
).
34
12
11
9. If required, make a fine adjustment by turning the control
dial for the fine adjustment (
13
) in 0.1 mm steps to the
desired level, whereby one whole turn corresponds
to 1 mm: Turn counter-clockwise to increase the milling
depth. Turn clockwise to decrease the milling depth.
13
10. After having adapted the fine adjustment, you can set the
scale below the control dial (
13
) to position “0”.
