EN
5
850W pendulum action jigsaw PJSS 13-230V
•
Immediately switch off the power tool if the insertion
tool blocks.
The power tool can lash out to the side owing
to the forces that build up consequently.
•
Wait until the power tool has come to a standstill,
before putting it down.
The insertion tool could get
caught resulting in a loss of control of the power tool.
Intended use
Only use the device
PJSS 13-230V
:
•
for straight and curved cuts at angular workpieces made of
wood, plastic and light metal while keeping base plate
contact,
•
for mitre cuts up to an angle of 45° at angular workpieces
made of wood, plastic and light metal,
whilst adhering to the technical data (see instructions).
We recommend using the power tool with original Trotec
accessories.
Foreseeable misuse
•
The device is not intended for processing damp wood.
•
The device is not intended for processing glass or stone.
•
The device is not intended for freehand operation without
base plate contact.
Any other use than the one described in the chapter "Intended
use" is regarded as reasonably foreseeable misuse.
Personnel qualifications
People who use this device must:
•
have read and understood the instructions, especially the
Safety chapter.
Personal protective equipment
Wear hearing protection.
Excessive noise can lead to hearing loss.
Wear eye protection.
With it you protect your eyes from splintering, falling
and flying pieces which could cause injuries.
Wear a protective mask.
It saves you from inhaling harmful dusts generated
when processing workpieces.
Wear protective gloves.
They protect your hands from burns, crushing injuries
and skin abrasions.
Wear tight-fitting protective clothing.
This protects you from the draw-in and entanglement
hazard posed by rotating parts.
Residual risks
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
Warning of electrical voltage
Work on the electrical components must only be
carried out by an authorised specialist company!
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Do not touch the mains plug with wet or damp hands.
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
Warning of electrical voltage
Electric shock due to lightning strike.
Do not work outdoors in case of approaching
thunderstorms.
In case of a thunderstorm, disconnect the device from
the mains.
The operator is responsible for the lightning protection
of the building.
Warning of laser radiation
Laser class 2, P max.: < 1 mW, λ: 400-700 nm,
EN 60825-1:2014
Do not look directly into the laser beam or the opening
from which it emerges.
Never point the laser beam at people, animals or
reflective surfaces. Even brief eye contact can lead to
eye damage.
Examining the laser output aperture by use of optical
instruments (e.g. magnifying glass, magnifiers and the
like) entails the risk of eye damage.
When working with a laser of class 2, observe the
national regulations on wearing eye protection.