EN
13
850W pendulum action jigsaw PJSS 12-230V
Info
The anti-splinter guard and the protective cover cannot
be used for mitre cuts.
Mounting the rip fence
The rip fence can be fastened on both sides of the device.
1. Loosen the locking screws (
15
) at the slot. Make sure not
to unscrew the locking screws completely.
8
15
2. Slide the rip fence (
8
) into the slot with the marking
pointing up.
3. Move the rip fence (
8
) into the desired position.
4. Tighten the locking screws (
15
).
Selecting the stroke rate
The required stroke rate depends on the material and the
operating conditions and can be determined by way of field-
testing.
The setting range covers the levels 1 – 6 (0 – 3,000 rpm). You
can change the preselected stroke rate level at any time.
1. Turn the setting wheel (
1
) to the desired stroke rate level.
1
Adjusting the pendulum action
You can adjust the pendulum movement of the saw blade.
Levels 1 to 3 allows for a faster work progress and level 0
(pendulum movement off) enables fine and clean cutting edges.
The ideal pendulum level for the respective application can be
determined by way of field-testing. Please observe the following
instructions:
•
If you want to obtain a fine and clean cutting edge,
preferably select a low pendulum level or switch off the
pendulum action completely.
•
Switch off the pendulum action when processing thin
materials.
•
Work at a low pendulum level when processing hard
materials.
•
For soft materials or when sawing wood with the grain you
can work with the maximum pendulum level.
1. Set the pendulum action selector switch (
5
) to the desired
level. The higher the level, the larger the pendulum stroke.
The pendulum action can also be adjusted during
operation.
I
II
III
0
5
Connecting the power cable
1. Insert the mains plug into a properly secured mains
socket.
