EN
11
cordless impact driver PIDS 10-20V
Using sockets
If you want to screw hexagon screws or nuts, you can use the
supplied square socket adapter (
10
) and a socket. To do so,
please proceed as follows:
1. Insert the square socket adapter (
10
) into the tool
holder (
1
) as described in the chapter Tool change.
2. Slide the matching socket onto the square socket
adapter (
10
) until it perceptibly clicks into place.
10
3. Check the socket for tight fit.
Operation
Wear hearing protection.
Excessive noise can lead to hearing loss. The sound
pressure level LpA of this device amounts to 93.9 dB(A).
Tips and notes on handling the cordless impact driver /
cordless impact wrench
General information:
•
Check the tool in the tool holder for proper fit before every
application.
•
The centre position of the clockwise / counter-clockwise
rotation switch (lock) is suited for work breaks or tool
change.
Screwing:
•
In case of soft wood, screws can be screwed in without
pre-drilling.
•
In case of hard wood or large screws, it is recommended
to use a drill for pre-drilling.
•
When using countersunk screws, the drill hole should be
countersunk beforehand.
•
Especially smaller screws and bits may be damaged when
selecting an excessive torque and / or speed at the tool.
Selecting the rotational direction
Note
To avoid damaging the gear, only change the rotational
direction when the device is at a standstill.
The motor's rotational direction can be changed by means of
the switch for clockwise / counter-clockwise rotation (
2
).
1. Press the switch for clockwise / counter-clockwise
rotation (
2
) in all the way on that side towards which the
motor shall rotate.
I.
II.
2
I.
Screwing in
II.
Unscrewing
2. Carry out a short test run to see whether the rotational
direction matches the intended application. A wrong
rotational direction may damage the tool and / or
workpiece.
3. If required, set the switch for clockwise / counter-
clockwise rotation (
2
) to centre position (lock) to block the
on/off switch (
3
).
