14
EN
cordless hammer drill PHDS 11-20V
Drilling in wood:
•
Use drill bits suitable for wood.
•
Place a block of wood under the workpiece or drill in from
both sides so that the wood cannot break off when it is
being drilled through.
•
Use a wood drill bit with centring tip. For deep drill holes,
use an auger bit; for large drilling diameters, use a
Forstner bit.
Impact drilling in masonry / bricks:
•
Use a drill bit suitable for masonry / bricks.
Selecting the rotational direction
Note
Only change the rotational direction when the device is
at a standstill! Otherwise the device might be
damaged.
The motor's rotational direction can be changed by means of
the switch for clockwise / counter-clockwise rotation (4).
1. Press the switch for clockwise / counter-clockwise
rotation (4) in all the way on that side towards which the
motor shall rotate.
I.
II.
4
I.
Screwing in
II.
Unscrewing
2. Carry out a short test run to see whether the rotational
direction matches the intended application. A wrong
rotational direction may damage the tool and / or
workpiece.
3. If required, set the switch for clockwise / counter-
clockwise rotation (4) to centre position (lock) to block the
on/off switch (5).
Switching the device on and off
The device has an infinitely variable speed control. The more
firmly you push the on/off switch (5), the higher is the speed.
1. Check whether the tool clamped in and the torque setting
selected are suitable for the intended application.
2. Check whether the workpiece is secured and the worktop
prepared correspondingly.
3. Press and hold the on/off switch (5) during screwing or
drilling.
ð
The device operates with the previously selected
settings.
ð
The LED work lamp (17) is illuminated.
5
17
4. Let go of the on/off switch (5) to stop the device.
ð
The LED work lamp (17) turns off.
Info
The motor has an integrated brake that quickly stops
the motor once you let go of the on/off switch (5).
Shutdown
1. Set the switch for clockwise / counter-clockwise
rotation (4) to centre position (lock).
2. If required, allow the device to cool down.
3. Remove the battery from the device (see Start-up chapter).
4. Remove the tool from the device (see Start-up chapter).
5. Clean the device according to the Maintenance chapter.
6. Store the device according to the Storage chapter.
