16
EN
cordless grass and shrub shears PGSS 10-20V
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch the device off.
•
Put the protective cover on the shear attachment.
•
If required, allow the device to cool down.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Remove the battery from the device (see Start-up chapter).
•
Remove the shear attachment from the mounting flange
(see Start-up chapter).
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the instructions.
Using insertion tools or accessories other than those
specified in the instructions may cause a risk of injury.
Designation
Article number
Multiflex 20V 2.0 Ah spare battery 6.200.000.303
Grass shears attachment
6.250.000.001
Shrub shears attachment
6.250.000.002
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The battery does not charge:
•
Check whether the battery is inserted correctly in the quick
charger.
Slide the battery into the quick charger in a way that the
battery terminals engage in the quick charger. The battery
must lock in place in the quick charger.
•
Check the power connection.
•
Check the power cable and mains plug for damage.
•
Check the on-site fusing.
•
Check the quick charger for damage. If the quick charger
is damaged, stop using it. Contact the Trotec customer
service.
•
Check the battery terminals for dirt. Remove any dirt.
•
The battery might be defective and have to be replaced.
Only use batteries of the same type.
The device does not start:
•
The battery power might be too low. Recharge the battery.
•
Check whether the battery is correctly connected to the
device.
Slide the battery onto the device in a way that the battery
terminals engage. The battery must lock in place in the
device.
•
Check the battery terminals for dirt. Remove any dirt.
•
The shear blade is jammed. Check the shear blade for any
potential obstruction caused by stones or branches. Do not
try to remove the obstruction during operation! Switch off
the device, remove the battery from the device and
carefully loosen the obstruction with a suitable tool. Never
reach into the shear blades directly with your hands.
Info
Wait for at least 10 minutes before switching the
device back on.
