EN
14
Operating manual – angle grinder PAGS 10-230
Switching the device on and off
Wear your personal protective equipment when working with
the device.
1. Check whether the mounted cutting disc is suitable for the
intended application.
2. Check whether the workpiece is secured and the worktop
prepared correspondingly.
3. Slide the on/off switch (5) forward to release the start lock.
4. Press the on/off switch (5) and hold it during operation.
5
5. Carry out a test run of approx. 1 minute without load prior to
every disc change and every start-up in order to check the
cutting disc for correct fit.
6. After switch-on, wait until the device has reached its
maximum speed. Only then start working.
7. To switch the device off, let go of the on/off switch (5).
Caution
The disc keeps running after the device has been
switched off.
Risk of injury.
5
Rotating the handle
The handle (4) can be rotated by 90° towards the left or right.
As a result the on/off switch might be located in a more
favourable position – depending on the application and
operating condition.
1. Press the release button (3) and turn the handle (4)
clockwise or counter-clockwise.
2. The handle (4) should click into place.
+90º
-90º
3
4
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
If required, allow the device to cool down.
•
Remove the tool from the device (see Start-up chapter).
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Storage chapter.
