EN
12
Operating manual – angle grinder PAGS 10-230
3. Use the pin-type face wrench (16) to unscrew the clamping
nut (15) counter-clockwise. Then let go of the spindle
lock (1).
1
15
16
4. Remove the used cutting disc (14). Make sure that the
mounting flange (13) is firmly locked in place in the
designated recesses.
14
13
5. Put the cutting disc (14) on the mounting flange (13).
The labelling must point to the device. Make sure that the
cutting disc hole fits the mounting flange without clearance.
Do not use any reducers or adapters.
14
13
6. If applicable, make sure that the rotation arrow on the
cutting disc corresponds to the rotational direction of the
device.
7. Screw the clamping nut (15) back on.
The flat side of the clamping nut must point to the device.
15
8. Press the spindle lock (1) to lock the gears.
