Trotec DH 15, Оригинальное руководство пользователя

Страница: 6 / 23

6 EN dehumidifier DH 15 / DH 30 / DH 60
Storage
Before storing the device, proceed as follows:
• Drain the remaining condensate from the device.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• in an upright position where it is protected from dust and
direct sunlight
• with a cover to protect it from invasive dust, if necessary
• Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
• 1 x Device
• 1 x Wall holder
• 1 x Condensation drain hose, 10 mm diameter
• 1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Always utilize the help of another person to assemble the
DH 15 / DH 30. Always utilize the help of two other persons to
assemble the DH 60. Do not try to assemble the device without
the help of another person. To lift the device, use a forklift or an
elevating truck as appropriate.
Observe the following instructions:
• When assembling the device, keep a sufficient distance to
heat sources.
• When assembling the device, especially in wet areas,
secure the device locally with an RCD (Residual Current
protective Device) which complies with the relevant
regulations.
• Make sure that extension cables are unrolled completely.
• Insert the mains plug into a properly secured mains
socket.
• When assembling the device, observe the minimum
distance from adjacent walls or other objects as described
in the Technical Data chapter.
C
C
A
B
D
Assemble the device as follows:
Select screw and wall plug sizes suitable for the weight of the
device (see technical data) and the structure of the wall.
DH 15
1. Mark the position for the bore holes.
2. Drill the holes into the wall.
3. Insert suitable wall plugs into the drill holes.
I. III. II.