EN
7
digital multimeter BE49
Scope of delivery
•
1 x Multimeter
•
1 x Safety measuring lines with test probes
•
2 x AAA battery
•
1 x Quick guide
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
When transporting the device, ensure dry conditions and and
protect the device from external influences e.g. by using a
suitable bag.
Storage
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
protected from dust and direct sunlight
•
the storage temperature complies with the values specified
in the Technical data
•
Remove the batteries from the device.
Operation
Warning of electrical voltage
Electric shock due to contact with live parts! When
using the measuring tips, make sure not to reach
behind the protection against contact.
Inserting the batteries
Insert the batteries before first use.
Note
Disconnect the measuring tips from the device before
opening the battery compartment.
Note
Make sure that the surface of the device is dry and the
device is switched off.
1. Loosen the screw at the battery compartment (11).
2. Open the battery compartment.
3. Insert both batteries in the battery compartment (+/-) with
correct polarity.
4. Close the battery compartment and retighten the screw.
Attaching the warning signs
Prior to initial start-up, check whether the warning signs at the
rear of the device are in your local language, if not, paste the
proper ones over it. Warning signs in your native language are
supplied along with the device. Please proceed as follows to
attach the warning signs to the rear of the device:
1. Remove the label for the battery compartment in your local
language from the supplied film.
2. Affix the label in the intended position on the battery
compartment (11) of the device.
3. Remove the label for the fuse compartment in your local
language from the supplied film.
4. Fold out the stand on the back of the device and affix the
label in the intended position on the fuse compartment (10)
of the device.
10
11
