6
EN
air cleaner AirgoClean® 350 E
Assembly and start-up
Scope of delivery
• 1 x Device
• 2 x HEPA carbon filter
• 2 x Prefilter
• 1 x Remote control
• 1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
The HEPA carbon filters are pre-installed.
Note
Remove the plastic cover from the HEPA carbon filters.
To do so, please proceed as described in the chapter
Changing the HEPA carbon filter.
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D
• Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
• Only put up the device in an upright, stable position on firm
ground.
• Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
• Make sure that extension cables are completely unrolled.
• Position the device near the source of air contamination.
• When positioning the device, keep a sufficient distance to
heat sources.
• Make sure that no curtains or other objects interfere with
the air flow.
• Make sure that the air inlet and outlet are not obstructed.
Connecting the power cable
• Plug in the mains plug of the power cable at the back of
the device.
• Insert the mains plug into a properly fused mains socket.