EN
11
air cleaner AirgoClean® 170 E
6. Put the device cover back on the device. To do so, insert
the lower hooks of the device cover into the corresponding
notches of the device and then push the top of the cover
onto the device. Make sure that the cover is fitted
correctly.
5
Changing the HEPA carbon filter
Note
Do not operate the device without a HEPA carbon filter
inserted!
Note
The HEPA carbon filter is not washable. Do not use
water or liquid cleaning agents to clean the HEPA
carbon filter.
•
The HEPA carbon filter has to be replaced if the
filter
change
LED (
13
) flashes or if the filter is dirty, which
manifests itself e.g. through reduced capacity (see chapter
Errors and faults).
•
Make sure that the HEPA carbon filter is installed before
switching the device on.
•
Without the HEPA carbon filter, the device cannot fulfil its
air cleaner function, and the inside of the device will be
soiled.
The HEPA carbon filter should be replaced in case of heavy
soiling.
The operating life of the HEPA carbon filter is approx. 6 months,
depending on the degree of air pollution.
If required, visually inspect the HEPA carbon filter for dirt.
1. Remove the rear device cover (
5
) from the device. To do
so, grab it by the side notches.
2. Pull the strip (
15
) to take the used HEPA carbon filter (
14
)
out of the device.
14
5
15
3. Dispose of the used HEPA carbon filter according to the
national regulations.
4. Take the new HEPA carbon filter out of the plastic cover.
The front of the HEPA carbon filter is fitted with a strip.
5. Insert the new HEPA carbon filter into the device. Make
sure that the strip of the filter is positioned on the outside.
Push the filter into the device until it is positioned flush
with the notch at the bottom of the device.
14
15
6. Put the device cover back on the device. To do so, insert
the lower hooks of the device cover into the corresponding
notches of the device and then push the top of the cover
onto the device. Make sure that the cover is fitted
correctly.
5
7. Press the
fan speed
button (
11
) for two seconds to reset
the
filter change
LED.
ð
The
filter change
LED goes out and the device enters
standby mode.