EN
5
air cleaner AirgoClean® 150 E
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with a carry
handle.
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
After
transporting the device, observe the following:
•
Set up the device in an upright position after transport.
Storage
When the device is not being used, observe the following
storage conditions:
•
Dry and protected from frost and heat
•
In an upright position where it is protected from dust and
direct sunlight
•
With a cover to protect it from invasive dust, if necessary
Assembly and start-up
Scope of delivery
•
1 x Device
•
1 x prefilter with integrated HEPA carbon filter
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
The HEPA carbon filter is pre-installed.
Note
Remove the plastic cover from the HEPA carbon filter.
To do so, please proceed as described in the chapter
Changing the HEPA carbon filter.
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical data.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Only put up the device in an upright, stable position on firm
ground.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Position the device near the source of air contamination.
•
When positioning the device, keep a sufficient distance to
heat sources.
•
Make sure that no curtains or other objects interfere with
the air flow.
•
Make sure that the air inlet and outlet are not obstructed.
Connecting the power cable
•
Insert the mains plug into a properly fused mains socket.
