10
EN
radiant heater IR 2050 / IR 3050
IR 3050
Note
Initially, always start the device at level 1.
Subsequently, you can switch over to level 2 or 3, if
required.
11
8
9
10
12
No. Designation
Meaning
8
Transmitter
Sends signals to the device.
9
Power button
For switching the device on and off
10
P2
button
To select heating capacity level 2
(2000 W)
11
P3
button
To select heating capacity level 3
(3000 W)
12
P1
button
To select heating capacity level 1
(1000 W)
Setting the heating level
1. Set the on/off switch (2) on the device to
I
.
ð
The operating light (1) flashes red.
ð
The device is now in standby mode.
2. Press the power button (9) on the remote control.
ð
The operating light (1) is illuminated in green.
ð
The device is switched on, but does not heat yet.
IR 2050
1. Press the corresponding button (10, 11, 12) to set the
desired heating level.
ð
During operation the operating light (1) is permanently
illuminated in green.
ð
The device heats.
IR 3050
1. Press the
P1
button (12) to switch the device on at level 1.
ð
During operation the operating light (1) is permanently
illuminated in green.
ð
The device heats.
2. To set a higher heating capacity press either the
P2
button (10) or the
P3
button (11).
Switching the device on
Once you have completely installed the device as described in
the Start-up chapter, you can switch it on.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
Info
If you switch off the device via the remote control, the
device will be set to standby mode. If standby
operation is not required, you can switch the device off
via the on/off switch (2).
•
Switch off the device by pressing the Power button (9) on
the remote control. Then set the on/off switch (2) on the
device to
0
. The operating light flashes red.
•
Allow the device to cool down completely.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Designation
Article number
remote control IR 2050
7.140.000.575
remote control IR 3050
7.140.000.042
