6
EN
convector TCH 1510 E / TCH 2510 E
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch the device off.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Allow the device to cool down sufficiently.
After
transporting the device, proceed as follows:
•
Place the device on its feet.
Storage
Before
storing the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
•
1 x Convector
•
2 x Foot
•
4 x Screw (for foot)
•
1 x Wall holder
•
2 x Screw (for wall holder) and 4 x screw and wall plugs
(for wall)
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Feet assembly
1. Place the device on its front side.
2. Fasten both feet (
1
) with four screws each.
1
3. Check the feet (
1
for tight fit.
4. Set the device up in an upright and stable position.
