EN
11
convector TCH 1510 E / TCH 2510 E
Frost monitor mode
In
frost monitor mode
( ) the devices heats automatically if the
room temperature is below 5 °C. This temperature cannot be
changed.
ü
The device is switched on and the
On /off
button (
9
) has
been actuated.
1. Press the
Mode
button (
14
) until the symbol (
7
) appears
on the control panel.
2. Press the
OK
button (
11
) to set the frost monitor mode.
3. Press the
Increase value
button (
12
) to set the frost
monitor mode to
ON
.
4. Press the
OK
button (
11
) to confirm the selection.
ð
The device heats as soon as the room temperature is
below 5 °C. It stops heating as soon as the room
temperature exceeds 5 °C.
ð
The symbol (
7
) appears on the control panel.
Please proceed as follows to switch off the frost monitor mode:
ü
The frost monitor mode is switched on.
1. Press the
Mode
button (
14
) until the symbol (
7
) appears
on the control panel.
2. Press the
OK
button (
11
).
3. Press the
Increase value
button (
12
) to set the frost
monitor mode to
OFF
.
4. Press the
OK
button (
11
) to confirm the selection and to
exit the frost monitor mode.
ð
The symbol (
7
) no longer appears on the control
panel.
Open window detection
The
open window detection
is deactivated by default. Please
proceed as follows to activate the function:
1. Press the
OK
button (
11
).
2. Press the
Increase value
button (
12
).
3. Press the
On/off
button (
9
) to confirm the function.
ð
If the temperature quickly decreases by 5 °C, the
current operating mode is quit instantaneously.
ð
The symbols (
7
) and (
7
) are displayed on the
control panel.
Switching the locking function on and off
The locking function prevents the buttons on the control panel
from being used.
Please proceed as follows to lock the control panel:
1. Press the
Mode
button (
14
) until the symbol (
7
) appears
on the control panel.
2. Press the
OK
button (
11
) to lock the control panel
ð
After 3 seconds, an acoustic signal is emitted.
ð
The locking function is activated.
ð
The buttons on the control panel cannot be used.
3. Press the
Mode
button (
14
) again to switch the swing
function off.
ð
The device switches back to the previous operating
mode.
Operating hours display
Proceed as follows to display the expired operating hours:
1. Press the
Mode
button (
14
) until the symbol (
7
) appears
on the control panel.
2. Press the
OK
button (
11
) to display the expired operating
hours.
ð
Only full operating hours (
10
) are displayed.
3. Press the
Mode
button (
14
) or the button (
7
) to exit the
preview.
ð
The operating hours are indicated in full hours. The
example shows 1,503 operating hours.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
1. Switch off the device by pressing the
On/off
button (
9
).
ð
The device is now in standby mode.
2. Set the On/off switch (
4
) to position
O
to switch the device
off.
3. Hold onto the mains plug while pulling the power cable out
of the mains socket.
4. Allow the device to cool down sufficiently.
5. Clean the device according to the Maintenance chapter.
6. Store the device according to the Storage chapter.
