EN
5
condenser dryer DH 95 S
Device depiction
1
2
3
4
5
6
6
8
4
7
No.
Designation
1
control panel
2
condensation tray indicator light with buzzer
3
button for draining residual water from the
condensation tray
4
air outlet
5
wheels
6
air inlet with air filter
7
condensation drain hose connection
8
air filter
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with wheels.
Always utilize the help of another person to transport the device.
Do not try to transport the device without the help of another
person. To lift the device, use a forklift or an elevating truck as
appropriate.
Before
transporting the device, observe the following:
•
Wait until the condensate pump stops pumping
condensate.
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Remove the condensation drain hose.
•
Only wheel the device on a level and smooth surface.
After
transporting the device, observe the following:
•
Set up the device in an upright position after transport.
•
After having transported the device in horizontal position,
leave the device to rest for 12 to 24 hours, so the
refrigerant can accumulate within the compressor. Wait
12 to 24 hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. Any warranty claims will be voided
in this case.
Storage
Before
storing the device, proceed as follows:
•
Drain the remaining condensate from the device and the
condensation drain hose (see chapter Maintenance).
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust, if necessary
•
Place no further devices or objects on top of the device to
prevent it from being damaged.
