P4
1D.
Hanging the fan
(For Downrod mount)
Rotate fan so that the groove on the ball engages
the ridge in the mounting bracket.
Lift fan assembly onto mounting bracket.
Mounting
Bracket
Ridge
Ball Groove
Mounting
Bracket
Insert the cross pin through yoke & downrod and secure with cotter pin.
Tighten both downrod jam screws to further secure downrod.
Pull down the yoke cover to cover yoke.
Insert 4 wires and through holes of Gasket (Removed from Step
), and put the Gasket back into
downrod assembly.
2
5
6
7
8
Cross Pin
Yoke
Cotter Pin
Downrod Jam
Screw(2)
(Tightening)
6
5
Yoke cover
7
Gasket
8
Downrod Assembly
Wires
5
1E. Canopy Assembly
(For Flush mount)
Canopy
decorating cap
Canopy
Big Screw & Washer (3)
2
1 3
Fan assembly
Big Screw & Washer (3)
Small Screw & Washer (3)
Top of Fan Housing
3
1E. Canopy Assembly
(For Flush mount)
Remove three big screws with washers and keep them for Step
.
Remove canopy decorating cap from bottom of canopy.
Put the canopy onto yoke, and fasten with three big screws with washers removed from Step
.
1
2
3
Note :
There are three big screws and three small screws pre-attached on top of fan
.
assembly
1
3
1C (Continued)
