Chapter 1
Tropos 7320 Router Installation Guide
18
4.
Attach the sun shield of the router to the structure with three 5/16-inch machine screws.
Insert one screw through the hole in the center back of the sun shield and the other two
screws through the curved slot tracks.
5.
To level the assembly, slide the router loosely into the sun shield, but do not secure it. Level
the sun shield by rotating the unit along the curved slot tracks. A built-in level is located on
the left side of the shield. Maintain the level orientation while you slide the router out of the
sun shield. Tighten the sun shield screws.
6.
Slide the router into place and secure it at the end with four #10-32 hex head machine
screws.
To continue installing the router, see
“Connecting Cable Attached Antennas”
Connecting Cable Attached Antennas
This section applies to external antennas used with the Tropos 7320 router. You can mount the
antenna on a structure and then use cables to attach it to the router. After mounting, secure the
antennas with ThreadLocker Loctite 242 and waterproof them using self-fusing EPR tape. (See
on page 68 for the correct part number.)
shows an
installation with external antenna cabling.
Warning
Do not locate the antenna near overhead power lines or other electric light or power circuits, or where
it can come into contact with such circuits. When installing the antenna, take extreme care not to come
into contact with such circuits, as they can cause serious injury or death. For proper installation and
grounding of the antenna, please refer to national and local codes (e.g. U.S.:NFPA 70, National
Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
