11
Stoneworks® Top Attachment
Step 1
CAUTION: It is the assembler’s and user’s
responsibility to confirm and install proper
length screws to prevent damage to the Top.
Place one screw into the Table Base. Measure
the length of the screw threads to insure they
stick up ½” – ¾”.
x
If the screw sticks up more than ¾”, do NOT proceed.
The screws are too long and will stick up through the
Top surface.
x
If the screw sticks up less than ½”, do NOT proceed.
The screws are too short and will not properly secure
the Top.
Step 2
Prepare a smooth, non-scratch work surface (shipping container, a
tarp or pool towels can be used). With two persons, place the Table
Top upside down on the prepared work surface. With two persons,
gently place the Base upside down onto the Top.
Step 3
Tops with Umbrella Hole
Center the Base on the underside of the Top; sight down through
the umbrella support ring in the Base and align it to the Top.
Square, Rectangular
Tops: Align the Base to the corners
of the Top.
Round
Tops: Continue to step 4.
Oval
Tops: Align the Base to the edges of the Top.
Tops without Umbrella Hole
Center the Base on the underside of the Top.
Square, Rectangular
Tops: Align the Base to the corners
of the Top. Measure equal distances at (4) places from the
corner of the Top to the leg mount.
Round, Oval
Tops: Measure equal distances at (4) places
from the edge of the Top to the leg mount.
12
Proper Base to Top Orientation
Square
Rectangular
Round
Oval
Step 4
Attach the Base to the Top using the supplied self-tapping screws.
NOTE: After assembling one Table, turn the Table upright.
Confirm the screws have not penetrated up through the top
surface.
With two persons, lift the table upright while holding the Base near
the (4) outermost Base to Top connection points.
Check that all the screws are firmly tightened to retain the Top.
Screws included with the base are specific for Tropitone
Stoneworks Table Tops only. Do not use with OEM tops.
