3
Step 2
Install the (4) Curtain Rod Brackets onto the
Curtain Rods using (4) ¼-20 x 1-1/4” Flat
Head Screws. Make sure the Curtain Rod
Bracket is positioned on the Curtain Rod so
the Bracket can receive the Arm in Step 3
as shown in the cutaway diagram. Fully
tighten the screws, but do not over tighten
and strip the threads.
Step 3
On Cabana Models w/no Vent
Install the Finial (decorative top) onto the Upper
Frame Assembly (cover already installed). Fully
tighten.
On Cabana Models w/Vent
Install the Vent to the Upper Frame Assembly
and secure to arms with snaps and the
Velcro Straps. Then install the Finial onto the
Upper Frame.
With two or more persons, carefully
open the Upper Frame Assembly to
the full open position.
Place the Upper Frame Assembly onto the
Corner Brackets with the Arms in the
Bracket channels (at 4 corners).
Position the center arms into the
Curtain Rod Brackets (4 places).
Install the ¼-20 x 1-3/4” Socket Head
Screw with ¼” Flat Washer into the
Curtain Rod Brackets (4 places).
Secure with ¼” Flat Washer and ¼-20
Locking Nut. Fully tighten.
ROD
ARM
(INSTALLED AT STEP 3)
BRACKET
4
Step 3
(Continued)
Install the ¼-20 x 1-3/4” Socket Head
Screw with ¼” Flat Washer into the
Corner Bracket Assembly (at 4
corners). Secure with ¼” Flat Washer
and ¼-20 Locking Nut. Fully tighten.
Fully tighten (8) ¼-20 x 2-1/2” Screws
and ¼-20 Locking Nuts to secure the
Curtain Rods to the Corner Bracket
Assemblies (8 places).
Step 4
Using (2) persons, lift one side of the
Cabana high enough to insert (2) Corner
Poles. Install Poles with Valance Supports
facing out. (Corner Pole with Valance
Support shown in diagram at below right)
Install ¼-20 x 3” Socket Head Screws with
¼” Flat Washers into pre-drilled holes to
hold Corner Poles to Corner Bracket
Assemblies. Secure with ¼” Flat Washers
and ¼-20 Locking Nut. Fully tighten (2
places).
Valance
Support
