TRONXY D01, Руководство пользователя и инструкция по установке

Страница: 13 / 20

Load and unload filaments
：
After waiting for temperature up to 180
℃
, filament go through from
the filament detection, extruder and feed pipe to the nozzle until the
filaments are squeezed , as the following picture shows :
Straighten
Filament
Print test
：
Click →
“
TEST FILE
”
→
，
Start printing
11
Filament run
out detection
Extrusion
Feed pipe
Click 23/0
23/199
1. When you print the first layer , the filament is not stick into the
hotbed , it is because the nozzle position is high . Reversing the
hand screw nut in counterclockwise direction or set the lower
position of the fist layer when slicing.
2. If the nozzle has a small mount of filament flowing , it is
because the position of nozzle is low . Reversing the hand screw
nut in clockwise direction or set the higher position of the first
layer when slicing.
（
The opposite way of the first suitation
）