S1
S2
S3
S1
S2
S3
S1
S2
S3
RF Dual Color Remote Controller
09.289ST.04165
Function introduction
Important:
Read All Instructions Prior to Installation
Output
RF signal
Operation Frequency
869.5/916.5/434MHz
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimensions
120x55x17mm
Front side
Bottom side
•
Control 4 zones of RF receivers separately.
• CCT color controller
• High sensitive & high stable, fast & precise color control.
• Compatible with all universal series RF receivers
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
Product Data
Safety & Warnings
Power Supply
4.5V(3xAAA battery)
Indicator: indicate the
state of remote control
Touch color wheel, touch to select
color temperature
Press and hold down to
increase/ decrease light intensity
75% brightness
100% brightness
25% brightness
50% brightness
Click to turn ON/OFF all zones
Press and hold down to save colors;
Click to recall the saved colors
Zone numbers:Click to choose
the zone/zones, Press and hold
down to turn on/off corresponding
zone
4.5V(3xAAA battery)
•
This device contains AAA batteries that shall be stored and disposed properly.
•
DO NOT expose the device to moisture.
Pair with RF receiver(Method 1)
Step 4:
Choose and click a zone number(
e.g.
zone
4
)
Step 3:
Click the “
Learning Key
” button on RF receiver or re-power on the receiver
three times continuously to set it into pairing status
Learning
Key
RF LED Receiver
Step 1:
Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 5:
Touch the color wheel, LED lights connected with the RF receiver flicker
once means the receiver is paired with zone 4 successfully.
Step 2:
Click
ON/OFF
button to activate the remote
Pair with RF receiver(Method 2)
Step 4:
Choose and click a zone number(
e.g.
zone
4
) twice, then press and hold it
continuously and quickly within 10 seconds, LED lights connected with the RF receiver
flicker once means the receiver is paired with zone 4 successfully.
Step 3:
Power off and power on the receiver
Learning
Key
RF LED Receiver
Step 1:
Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 2:
Click
ON/OFF
button to activate the remote