14
TUNING AFTER APPLYING NEW STRINGS
●
Turn manually the key of the RoboHead until the string is tight enough to give a
tone when plucked.
NOTE!
To ensure tuning stability, please stretch all strings. After applying the
strings you can grab a string slightly above the sound hole at the beginning of the
neck and pull it up about 1 inch in order to stretch it. You can do this several times
but make sure the device is still off.
●
Now you can switch on the NEWCOMER by holding the
ON
-button
for 3 - 4 seconds.
●
The system is now active in single string mode and the first LED (E) starts fla-
shing
RED
.
●
Now please pluck the string indicated by the
RED
flashing LED and let it ring
3-5 seconds until the LED turns
GREEN
. The system will automatically switch
to the next string to repeat the procedure for every string step by step.
●
If all LED’s are
GREEN
the guitar is in tune and you are ready to go.
NOTE:
New strings will still stretch a little bit after the first tuning. Please just retune
to make sure that the guitar is perfectly in tune.
FACTORY RESET
●
Make sure that NEWCOMER is turned OFF.
●
To restore factory settings please click the
ON
button briefly to switch on the device.
●
Now hold the on button for about 15 seconds until the device turns on the LED’s
start flashing
YELLOW
. NEWCOMER will turn off and the factory reset is restored.
BE AWARE!
●
Please read the manual carefully.
●
Never use a string winder tool.
●
Never try to tune manually when the system is ON/active.
●
Bring the battery to full charge before start up.
●
Check the status of the battery continually while using the NEWCOMER .
GREEN
= full of charge
RED
= out of charge
