Tronair 5731, Инструкция по эксплуатации и обслуживанию

Страница: 21 / 119

Model: 5731
Hydraulic Power Unit
08/2016 | Rev. 08 Page | 16
6.0 PACKAGING AND STORAGE
6.1 PACKAGING REQUIREMENTS
a. Drain hydraulic fluid until level is below the minimum fluid level indicator.
b. Block up the unit on a pallet so the wheels are not touching the pallet or shipping container.
c.
Plug all hose ends.
d. Strap unit to pallet or shipping container using the tie down rings located on the frame bottom.
NOTE: Use at least four (4) straps with a minimum 4,000 lb (1,814 kg) capacity each.
6.2
HANDLING
The unit is designed to be moved by hand using the handles located on the front of the unit. The unit can be lifted by means of
a fork truck from the center of the machine. Lifting must be from the motor side of the unit only.
NOTE: Be sure the forks are long enough to reach the frame cross members for stability during lifting. Spread the
forks to their maximum width for stability. Reference Figure 7.0

HPU on Forklift.
6.3
PACKAGING PROTECTION
No special packaging material for cushioning or suspension is required.
6.4 LABELING OF PACKAGING
Packaging should be labeled as follows: DO NOT DROP
THIS SIDE UP
DO NOT STACK
6.5 STORAGE COMPATIBILITY
No special considerations for short term storage (less than three months).
6.6 STORAGE ENVIRONMENT
Cover HPU with a suitable, non-abrasive tarp if storing outside. For storage periods greater than three months, drain hydraulic
fluid from all hoses and the reservoir. Cover unit to protect outside surface.
If storing outside, protect unit from freezing water, sand, dirt, and direct sunlight. A cover is highly recommended.
6.7 STORAGE SPACE AND HANDLING FACILITIES

Weight (Dry) : 3,500 lbs (1,588 kg)

Dimensions : Width 63 ¾ in (162 cm) Add 7.5 in (19 cm) for Dual System.
Height 59 in (149.9 cm)
Depth 78 in (198 cm)
7.0 TRANSPORTATION
1. Do not stack Hydraulic Power Units.
2. The unit can be lifted by means of a fork truck from the motor side center of
the HPU.
NOTE: Be sure the forks are long enough to reach frame cross members
for stability during lifting. Spread the forks to their maximum width for
stability. Reference Figure 7.0

HPU on Forklift.

Weight : 3,150 lbs (1,430 kg)
FIGURE 7.0

HPU on Forklift