Tronair 02-0544C0110, Руководство по эксплуатации и обслуживанию

Страница: 9 / 78

Models: 02-0544C0110 & 02A0544C0110
5 Ton (4.5 Metric Ton) - Single Stage Jack
04/2014 | Rev. 01 Page | 6
5.0 PACKAGING AND STORAGE
5.1 PACKAGING REQUIREMENTS
Jacks are to be packaged as required to prevent damage to legs or hydraulic equipment during shipment.
5.2
HANDLING
Jacks can be rolled by hand on its casters.
5.3
STRAPPING
Jacks can be strapped down by suitable means to prevent unwanted movement during shipment.
5.4
LABELING OF PACKAGING
Packaging should be labeled DO NOT DROP .
5.5
STORAGE ENVIRONMENT

Store jacks between -20

C and +50

C/-4

F and 122

F.

Always store jack with ram all the way down.

Suitable for outdoor storage by using a full coverage waterproof tarp or canvas.
5.6
STORAGE SPACE AND HANDLING FACILITIES

Minimum Closed Height: 44 in (111.76 cm)

Mechanical Extension: 10 in (25.4 cm)

Hydraulic Extension: 22 in (55.88 cm)

Maximum Height Obtainable: 76 in (193.04 cm)

Weight: 133 lbs (60.3 kg)
6.0 TRANSPORTATION
Lifting can be accomplished by crane and strap thru top of tripod, or by fork truck under lower tripod support. Approximate
weight is 133 lbs (60.3 kg).
7.0 ASSEMBLY
This product is shipped completely assembled and tested and requires no further assembly before operation. The following
sections apply when servicing the unit.
7.1
GENERAL INSTRUCTIONS
1. This product should be assembled and/or repaired using good workmanship practices and proper tools. Bolts and elastic
stopnuts should be tightened to a torque not to exceed industry standards for Grade '5' bolts.
2. All replacement parts must be the same as or better than the original parts supplied.
3. Dispose of waste per federal and local laws and regulations.
4.
No modifications are allowed that will adversely affect the jacks’ safety performance.
5. The pressure relief valve is not serviceable. It must be replaced as a unit.
6. Torque (3) 5/16
– 18 socket head cap screw to 35 ft lbs (47 Nm). Reference Parts List Item 57.
7.2
PRE-USE CHECKS
1. Refer to the Illustrated Parts List to identify and ensure that all parts are present.
2. Generally check over unit to assure the tightness of all nuts, bolts and fittings.
3. With rams completely collapsed, check hydraulic fluid level.

Replenish with MIL-PRF-5606 fluid as required.

Fluid Level : 1.5 in (3.8 cm) below vent.
NOTE: Refer
to fluid manufacturer’s (Appendix) Material Safety Data Sheet, and advisory for handling and disposal
of fluid.
7.3
PERSONNEL REQUIREMENTS
This jack is to be assembled by qualified technicians familiar with hydraulic systems.
7.4
INSPECTION AND TEST PROCEDURES
1. Ensure fluid level is within 1.5 inches (3.8 cm) from reservoir vent cap.
2. Raise ram to full stroke, and check for leaks.