Tronair 02-0511C0132, Руководство по эксплуатации и обслуживанию

Страница: 6 / 42

Model: 02-0511C0132
5 Ton Two Stage Jack
02/2017 | Rev. 04 Page | 3
5.0 ASSEMBLY
This product is shipped completely assembled and tested and requires no further assembly before operation. The following
sections apply when servicing the unit.
5.1
GENERAL INSTRUCTIONS

This product should be assembled and/or repaired using good workmanship practices and proper tools. Bolts and elastic
stopnuts should be tightened to a torque not to exceed industry standards for Grade '5' bolts.

All replacement parts must be the same as or better than the original parts supplied.

Dispose of waste per federal and local laws and regulations.

No modifications are allowed that will adversely affect the
jack’s safety performance.

The pressure relief valve is not serviceable. It must be replaced as a unit.
5.2 PRE-USE CHECKS
1. Refer to the Illustrated Parts List to identify and ensure that all parts are present.
2. Generally check over unit to assure the tightness of all nuts, bolts and fittings.
3. With rams completely collapsed, check hydraulic fluid level.

Replenish with MIL-PRF-5606 fluid as required.

Fluid level is full when 5/8 to ½ inches from the outside top of reservoir.
NOTE: R
efer to fluid manufacturer’s (appendix v) material safety data sheet, and advisory for handling and disposal
of fluid.
5.3
PERSONNEL REQUIREMENTS
This jack is to be assembled by qualified technicians familiar with hydraulic systems.
5.4
INSPECTION AND TEST PROCEDURES
1. Ensure fluid level is within 5/8 to ½ inches from the outside top of reservoir.
2. Raise ram to full stroke, and check for leaks.
6.0 OPERATION
6.1 OPERATING PARAMETERS

The user shall work in accordance with the Operator Manual

It is not allowed to work under the raised load until it is secured by suitable means, i.e. Ram Locknut

The employer of the operator shall provide for all necessary training and give information about pumping and translating
forces

Operate between -20

C and 50

C/-4

F and 122

F
6.2
NUMERICAL VALUES

Vertical capacity: 10,000 lbs. (44.5 kN)

Minimum closed heights:

with R-1013-01 mechanical extension 11.4 in (29 cm)

with R-1012-01 mechanical extension 17.5 in (44.6 cm)

Mechanical extension: 3.0 in (7.6 cm)

Hydraulic extension: 12.22 in (31 cm)

Maximum heights obtainable:

with R-1013-01 mechanical extension 26.6 in (67.6 cm)

with R-1012-01 mechanical extension 32.7 in (83.1 cm)

Overall: 14 ½ x 15 in (36.8 x 38.1 cm)

Floor area (triangular): 156 in² (1006 cm²)

Weight: 100 lbs (45.4 kg)