10254 - 9
STEP 4: HANDLEBAR INSTALLATION
• Remove two M8 x 15 Bolts (19) and two Ø16 x Ø8 x 1.5
Curved Washers (15) from the Handlebar Post (7). Remove
the Bolts using the S6 Allen Key.
• Insert the Hand Pulse Sensor Wires (49) into the hole on
the Handlebar Post (7) and then pull them out of the top
end of the Handlebar Post (7).
• Attach the Handlebar (8) onto the Handlebar Post (7) with
two M8 x 15 Bolts (19) and two Ø16 x Ø8 x 1.5 Curved
Washers (15) that were previously removed. Tighten bolts
with the S6 Allen Key.
4. ASSEMBLY STEPS (CONT. )
Recheck
all bolts and nuts are
tightened securely
before using the machine
CAUTION:
Ensure that cables are not damaged
during assembly or when tightening screws.
CAUTION:
Ensure that cables are not damaged
during assembly or when tightening screws.
STEP 5. COMPUTER INSTALLATION
• Remove four M5 x 10 Bolts (42) from the Computer (56) using the Multi
Hex Tool provided.
• Connect the Hand Pulse Sensor Wires (49) and Extension Sensor Wire
(57) to the wires that come from the Computer (56). Tuck wires into the
Handlebar Post (7).
• Attach the Computer (56) onto the top end of the Handlebar Post (7)
with four M5 x 10 Bolts (42) that were previously removed. Tighten bolts
with the Multi Hex Tool provided.
Adjusting the Tension Control Knob
• To increase the load, turn the tension control knob in a clockwise
direction.
• To decrease the load, turn the tension control knob in a counter
clockwise direction.
Adjusting the Adjustable Leveler
• Turn the adjustable level on the rear stabiliser as needed to level the
upright bike.
Adjusting the Seat Height
• Turn the Seat Post Knob in a counter clockwise direction until it can be
pulled out. Pull out the Seat Post Knob and then slide the Seat Post up or
down to the suitable position. Lock the Seat Post in place by releasing the
Seat Post Knob and sliding the Seat Post up or down slightly until the Seat
Post Knob “pops” down into the locked position. Tighten the Seat Post
Knob in a clockwise direction.
NOTE
: When adjusting the height of seat post, make sure the Seat Post
bushing does not exceed the mark line on the seat post.
