AWC7813 motion controller user manual
WWW.SZTROCEN.COM
89
4.2 Why does the prompt "Engrave beyond border
limit!" appear
Assuming that the blue rectangle is an engraving file, the engraving track of the
laser head is as shown in the figure above. To distinguish the speed, set the trajectory
of the laser head idling on the outside as a dotted line, and set the trajectory of the
laser head during engraving as a solid line. In order to achieve a certain engraving
speed, the distance from the laser head to point A must be increased, and after
reaching point B, it will be decelerated.
If the positioning point is set too far, it will easily cause the laser head to go
beyond the boundary during idling on the outside. Once the boundary is exceeded, it
will prompt "Engrave beyond the border limit!" and the machine will stop operating.
At this time, you need to adjust the positioning point in time, taking into account the
distance that the laser head travels outside. Please refer to the definition of anchor
point
.
At the same time, when the
【
Engrave Acc
】
is too small, the distance of the
laser head travels too long, which will easily lead to out of bounds. At this time,
【
Engrave Acc
】
should be increased. Please refer to the definition of
【
Engrave Acc
】
4.3 Why does the prompt "Beyond border limit!
Continue?" appear
When the following situations occur, it will prompt "Beyond border limit!
B
A
